N&W Global Vending Kobalto Installation Operation & Maintenance - page 40
© by N&W GLOBAL VENDING S.p.A.
36
05-2008 3235-00
StatIStIcS
the operation data of the machine are stored in general
and relative counters that can be reset without losing
total data.
tecH>
statIstIcs
tecH>
“list of statistics”
E
lEcTroNic
couNTEr
an electronic counter is intended to store all the dispens-
ing cycles you have performed since you last reset it in
an aggregated manner.
g
ENEral
Display
press the enter key to display the data you have stored
in sequence, i.e:
1 - counter by single selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
g
ENEral
rEsET
Statistics can be reset either globally (all types of data)
or selectively, i.e. by:
- selections
- discounts-overprices
- failures
- coin mechanism data
press the enter key to display the request for confir-
mation “Do you confirm?” flashing on and off.
press the enter key to display the “execution” message
for some seconds and to reset statistics.
r
ElaTiVE
Display
press the enter key to display the data you have
stored in sequence, subdivided just as general statistics.
r
ElaTiVE
rEsET
Statistics can be reset either globally (all types of data)
or selectively, just as general statistics.
E
NabliNg
THE
ElEcTroNic
couNTEr
aT
sTarTup
Function used to enable or disable the display of the
total number of dispensing cycles that have been sold
since you last reset, while you are powering on the ma-
chine.
p
riNT
connect an rs232 serial printer having 9600 baud rate,
8 data bits, no parity, 1 stop bit with the serial port on the
button board in order to print all the statistics described
by the “statistics display” paragraph.the machine data
as well as the software date and release are also printed.
statistics can be printed either partially or totally.
to connect the printer, act as follows.
- press the enter key to display the request for confir-
mation “Do you confirm?”;
- connect the printer before confirming;
- press the enter key to start printing.
tESt
Use this group of functions to perform some checks on
the machine
T
EsT
DispENsiNg
Function used to dispense the following for every single
selection when the door is open and without inserting
the amount required:
tecH>
test
tecH>
“list of functions”
- complete selection
- water only
- powder only
s
pEcial
fuNcTioNs
access the function to act as follows:
u
NiT
TurN
- operate the brewing units (espresso) you have actually
mounted;
D
osE
DispENsEr
- dispense a ground coffee dose; press the keys and
to choose the grinder on which to act; press the
enter key and the keys and to select the (low or
high) dose that will be released by pressing ;
b
oilEr
DiscHargE
- discharge water from the air break and open a solenoid
valve to let air flow in if boilers are emptied for mainte-
nance purposes;
m
aNual
iNsTallaTioN
- manual installation of boilers (the water circuit is filled
in);