N&W Global Vending Kobalto Installation Operation & Maintenance - page 15
© by N&W GLOBAL VENDING S.p.A.
11
05-2008 3235-00
Wash all the components by using detergents.
-
make sure that all visible residuals and films are
mechanically removed. If necessary, use a brush
sanitize by making use of sanitizing agents.
dip the components into a container of sanitizing solu-
-
tion you have prepared before for about 20 min;
reassemble the collection boxes and the water funnels;
-
reassemble the powder deposit drawers and the pow-
-
der funnels after having carefully dried them.
after having mounted the parts, it is anyway nec-
-
essary to act as follows:
pour some drops of the sanitizing solution into the
-
mixer;
rinse the parts in question abundantly to remove any
-
residual of the solution you have used. Use the mixer
washing function when the door is closed.
dISaSSEmbLINg aNd cLEaNINg tHE
mILKEr
the device intended to dispense hot milk (milker) shall
be carefully cleaned and sanitized at the time of the
installation of the machine and at least once a week or
more frequently, according to the use of the machine and
the type of milk in use in order to guarantee the compli-
ance of dispensed products with sanitary rules.
the parts to be cleaned are listed here below:
milker intended to dispense milk, to be disassembled in
-
all its parts;
Fig. 12
Milker
1-
Dividing nozzles (coffee + milk)
2-
Milker components
3-
Nozzle telescopic cover
4-
Brush
5-
Nozzle support
6-
Milk suction tube
7-
Flow rate regulator
8-
Dividing nozzle cover
9-
Dividing nozzle body
10-
Milk container
11-
Tube disconnection rubber-holder
12-
Fig. 11
Knurls for fastening the telescopic cover
1-
Nozzle support
2-
Dividing nozzle
3-
Brush for cleaning tubes
4-
Dispensing nozzles
5-
Tubes for dispensing instant products
6-
Funnel fastening ring nut
7-
Mixer impeller
8-
Water funnel
9-
Powder deposit drawer
10-
Product funnel
11-
Product collection box
12-