N&W Global Vending Koro Prime Espresso Installation, Operation & Maintenance Manual - page 36
© by N&W GLOBAL VENDING S.p.A.
28
01-2016 4875 00
D
isplay
The function is intended to sequence-display the same
data you can obtain by printing statistics.
Press the Enter key
to sequence-display the follow-
ing data:
t
otal
couNt rs
1 - counter by selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
r
lativ
couNt rs
1 - counter by selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data
D
l t
Statistics can be reset for relative counters either glob-
ally (all types of data) or selectively for:
-selections
-discounts
-failures
-coin mechanism data
Press the Enter key
to display the blinking message:
“Do you confirm?”
Press the Enter key
to reset the statistics. The
display shows the “Running” message during the
operation and statistics are reset.
INDIVIDUAL PRICE
The machine can manage up to 4 different prices per
selection, which can be active according to the time
band you have set (standard or promotional) and/or the
payment system in use.
Use this function to vary the sales price for every single
selection by selecting among the price ranges available.
MANAGEMENT OF CHANGE TUBES
This function is active only if this operation can be
carried out by the payment system you have set up.
Access the function to manually load or empty the
change tubes.
If you confirm loading,
“Credit : ——” will appear on the display. This is the value
of the money made available in the tubes for the change.
If you insert a coin into the validator, the display will
increase the value of the money made available in the
tubes for the change.
If you confirm unloading, you can establish the tube on
which you wish to act. Whenever you press the Enter key
, a coin is ejected by the active tube.
TEST DISPENSING
Possible test dispensing cycles are listed here below (for
every single selection):
-Complete dispensing
-Water-only dispensing
-Powder-only dispensing
Please Note For the selections based on espresso
coffee, partial powder and water dispensing cycles
are intended to dispense additions only; if no ad-
dition is involved in the selection, the display will
show “Disabled Sel”.
D caff
flap
simulatioN
If the door is open, the decaff flap magnet (if any) can
not be properly detected.
A symbol simulating the flap status is displayed on the
first line of the display after the number and the active
menu function:
= Flap closed (grinding occurs during test selections);
= Flap open (grinding fails to occur during test selec-
tions);
to change the decaff flap simulator status, press the last
key on the right.