N&W Global Vending Koro Prime Espresso Installation, Operation & Maintenance Manual - page 45
© by N&W GLOBAL VENDING S.p.A.
37
01-2016 4875 00
f
ill r
m Nu
Nabl
To set up which functions of the filler menu shall be ena-
bled and which of them shall be disabled.
The reference numbers of the menus do not change
even if some are disabled.
s
top
s l ctioN
To enable the “dispensing stop” function of a drink.
While dispensing a drink, you can stop the dispensing
cycle manually by pressing the required selection key
once again.
xtractioN
faN
maNag m Nt
Makes it possible to enable or disable the operation of
the fan extracting instant powder residue and/or steam
during the preparation of instant drinks.
-ON extractor fan in continuous operation
-OFF extractor fan in operation only during the prepara-
tion of the drink and for the 30 subsequent seconds.
STATISTICS
All the machine operation data are stored in total and
relative counters that can be reset without losing total
data.
l ctroNic
couNt r
D
isplay
t
l ctroNic
couNt r
An electronic counter is intended to store all the dispens-
ing cycles you have performed since you last reset it in
an aggregated manner.
r
s t
t
l ctroNic
couNt r
You can reset the electronic counter.
D
isplay
v NDs
at
t
start
-
up
To enable / disable the display of the total number of dis-
pensing cycles that have been made since you last reset
the statistics, while you are powering on the machine.
p
riNt
This function is intended to print the data that have been
stored for the machine operation.
Connect an RS232 serial printer having 9600 baud rate,
8 data bits, no parity, 1 stop bit with the serial port on the
button board in order to print all statistics, i.e.:
t
otal
1 - counter by selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
r
lativ
1 - counter by selection;
2 - counter by band;
3 - discount counter;
4 - failure counter;
5 - coin mechanism data.
The machine code, the date and the software release
will be also printed.
To print, act as follows:
-From the print function press key
to display “Do you
confirm?”;
-connect the printer;
-Press the Enter key
to start printing