N&W Global Vending Koro Prime Espresso Installation, Operation & Maintenance Manual - page 44
© by N&W GLOBAL VENDING S.p.A.
36
01-2016 4875 00
m
isc llaN ous
j
ug
f
aciliti s
On some models complete with a special key you can
obtain a number (programmable from 1 to 9.5 by default)
of cup-free selections in order to fill in a jug.
p
assworD
passworD
s tup
It is a 5-digit numeric code you are required to enter to
access the programming mode.
The value of this code is set to 00000 by default
passworD
Nabl
To enable or disable the request for password function
for access to the programming mode. The request for
password is disabled by default.
couNt r
r s t
passworD
Use this function to set the password you shall type in
the normal operation mode (door closed) to reset the
selection counters.
If the password is set to 00000, the password is disa-
bled.
multipl
Disp NsiNg
passworD
To set the password you shall type in the normal opera-
tion mode (door closed) to dispense several selections
in consecutive mode to fill in a jug (jug facilities).
If the password is set to 00000, the password is disa-
bled.
f
r
v ND
passworD
Enter the password to dispense a drink without inserting
any credit.
k
yboarD
lock
passworD
Use the function to set up the password (to be entered
when the door is closed) to enable/disable the selection
keyboard lock.
The “Service interruption” message will appear on the
display during the key lock.
If the password is set to 00000, the password is not ac-
tive.
w
as iNg
passworD
Use this group of functions to set:
-Mixer washing password
Password to be entered in the normal operation mode
(door closed) to wash the mixers.
The keyboard assumes the numeric values supplied by
the figure at the beginning of the chapter.
-Unit washing password
Password to be entered in the normal operation mode
(door closed) to wash the espresso unit.
The keyboard assumes the numeric values supplied by
the figure at the beginning of the chapter.
t st
s l ctioN
passworD
To set up the password you shall type in the normal op-
eration mode (door closed) to access the maintenance/
programming mode and to perform test selections.
If the password is set to 00000, the password is disa-
bled.
filt r
r s t
passworD
Use this function to set up the password necessary to
reset the “replace the water filter” message when the
door is closed and to reset the corresponding counter
after having replaced the filter.