NAIM AV2 Owner's Manual - 9.0 Av2 Detailed Setup
10
9.0 av2 detailed setup
Only once all the desired input and output connections are made should the av2 setup
procedure be initiated. Although the av2 can be set up and controlled from its front panel,
many parameters are best set from the primary listening and viewing position, so setup
from the narcom av remote handset is recommended. It is important however that the av2
front panel is visible during setup because its display provides feedback of control
parameters. This is of less importance if a Video Switcher is connected as on-screen display
of setup parameters will then be available.
More! Operation of the av2 from the front panel is shown in bracketed italics.
More! Flash remote handsets running Version 2 software can also be used to
control the av2. For information on Flash software updates please contact your
dealer or local Naim Audio representative.
When initially powered up from the switch on the rear panel the av2 will, after a short
delay as internal house-keeping is carried out, be in Standby mode. Standby is indicated
by an illuminated Naim logo and a single dot indicator on the display. To wake the av2
press and hold the standby key (front panel: press and hold input or mode buttons). The av2
will wake-up in either the default state if it is previously unused, or in the state in which
it was last shut-down.
There are two independent setup “pages”; each with a setup routine to be executed: Input
Setup and Speaker Setup. Input Setup, which defines the type of source component
connected to each input, should be carried out first. Speaker Setup enables various
parameters and options for each speaker channel to be set.
More! Some speaker setup parameters are dependent on the selected av2 input
so setup may be simplified if the av2 is initially returned to its setup defaults. To
restore the default values separately in either setup “page” press and hold the
handset disp key while the av2 is in the desired setup mode. The display flashes
once to confirm.
To restore the default values simultaneously across both setup pages press and
hold the handset disp key while the av2 is in normal mode. The mode button will
flash, three bars appear in the display, and after a short delay the av2 will re-
awake in input setup mode. The factory default settings are shown in Section 11.
More! The av2 will drop out of either setup mode after 5 minutes if no keys or
buttons are operated.
More! It may help during setup to refer to the “quick setup” diagrams in
Section 6.
9.1
setup routine - inputs
The first av2 setup page and routine defines the type of source equipment connected to
each input and enables a remote control input function to be selected. To switch the av2
into Input Setup mode press the menu key followed by the i/p
key (front panel: press
and hold input button).
The complete list of source component display options available is as follows: DVD (DVD
video/audio), LD (laser disc), TV (television), SAT (satellite), CAB (cable service), HDR (hard
disk recorder), VCR (video cassette), GM (game console), PC (personal computer), PRE
(audio preamp), CD (compact disc), CDR (compact disc recorder), TUN (tuner), DAB (digital
tuner), MD (mini disc), DAT (digital audio tape), TAP (audio tape) AUX (auxiliary), DVA
(DVD audio) SCD (super audio compact disc).
The following order of setup steps is arbitrary. It is possible to move between setup steps
by pressing 2
or 8
(front panel: mode or input buttons).
av2
setup start