NAIM AV2 Owner's Manual - 9.0 Av2 Detailed Setup
15
9.0 av2 detailed setup
Step 16. Use the handset vol
and vol
keys initially to set a suitable volume. The test
signal should be heard through the Main Left speaker. The av2 display will show L on the
left hand side and a numerical value between -30 and +30 on the right hand side. L refers
to the Main Left speaker and the numerical value its relative volume level. Use the
4
or 6
keys (front panel: rotary control) to select volume level initially of around zero.
Move to the next step by pressing 8
(front panel: mode button).
More! If the test signal is not heard through the left main speaker the av2,
power amplifiers or speakers are not connected or set up correctly.
Steps 17 to 23. Repeat the step 16 procedure for the Centre (CEN), Main Right (R), Right
Surround (RS), Right Extra Rear (RR), Left Extra Rear (LR), Left Surround (LS) and Sub-
woofer (SUB) channels each time adjusting the volume using the
4 or 6
keys (front
panel: rotary control) to be similar to the previous speaker. It is always possible to return
to and adjust the previous speaker by pressing 2
(front panel: input button).
More! It may be helpful to cycle once or twice through all the speakers before
making any level adjustments.
More! If specific speakers have been previously defined as not present they will
not be included in the test.
More! If the test signal is not heard through the speaker designated in the left
hand side of the display at each stage, the av2, power amplifiers or speakers are
not connected or setup correctly.
More! Take care when exiting speaker setup mode that adjustment of the test
signal has not left the overall volume set at an excessive level.
Step 23 completes the av2 Speaker Setup routine. To exit from Speaker Setup mode press
the menu key followed by the mode
key (front panel: press and hold mode button).
Exiting from setup mode stores the settings selected for each parameter.
av2
speaker level adjustment
setup done