NAIM AV2 Owner's Manual - 9.0 Av2 Detailed Setup
12
Steps 12 to 14 of the Input Setup routine enable the adjustment of three parameters
dedicated to Dolby Surround Pro Logic II encoded programme material. These parameters
need not be changed from their default settings during Input Setup but may be adjusted
as required when appropriate programme material is used. In addition to their position as
the last three Input Setup parameters, they can also be more readily accessed by entering
Input Setup mode and pressing the handset 2
key (front panel: input button).
More! See Section 10.2 - 10.6 for further information on decode options and
principles.
Step 12. The av2 display will now show PAN on the left hand side and OFF or ON on the
right hand side. PAN refers to Dolby Surround Pro Logic II “Panorama” and when ON is
selected a proportion of the front stereo signal is fed to the surround channels. Use the
4 or 6
keys (front panel: rotary control) to select an option. Move to the next step by
pressing 8
(front panel: mode button).
Step 13. The av2 display will now show W on the left hand side and a numerical value on
the right hand side. W refers to Dolby Surround Pro Logic II “Centre Width” and the
numerical value to the strength of the centre channel in relation to the front left and right
channels. Selection of a higher value increases the relative strength of the left and right
channels. Use the
4 or 6
keys (front panel: rotary control) to select a numerical value.
Move to the next step by pressing 8
(front panel: mode button).
Step 14. The av2 display will now show D on the left hand side and a numerical value on
the right hand side. D refers to Dolby Surround Pro Logic II “Dimension” and the numerical
value to the balance between the front and surround channels. Selection of a higher value
increases the relative strength of the surround channels. Use the
4 or 6
keys (front
panel: rotary control) to select a numerical value. Move to the next step by pressing 8
(front panel: mode button).
Step 14 completes the av2 Input Setup routine. To exit from Input Setup mode press the
menu key followed by the i/p
key (front panel: press and hold input button). Exiting from
setup mode stores the settings selected for each parameter.
9.2
setup routine - speakers
The Speaker Setup routine defines the presence and size of the speakers connected to the
main, centre, surround, extra rear and sub-woofer outputs, their distance from the
listening position, and allows their relative volumes to be adjusted. To switch the av2 into
Speaker Setup mode press the menu key followed by the mode
key (front panel: press
and hold mode button).
More! Some parameter options in the speaker setup routine are interrelated. For
example, if NO is specified for a specific speaker its setup options will be
unavailable. Similarly if NO sub-woofer is specified only a default option will be
available for the main left and right speakers.
The following order of setup steps is arbitrary. It is possible to move between setup steps
by pressing 2
or 8
(front panel: input or mode buttons).
Step 1. The mode button indicator on the av2 front panel will flash, the display will show
LR on the left hand side and LG or SM on the right hand side. LR refers to the main left
and right channel speakers and LG (large), SM (small) to their size. Pressing either the
4
or 6
keys (front panel: rotary control) will prompt the right hand side of the display to
cycle though the SM and LG options. Select either option and move to the next step by
pressing 8
(front panel: mode button).
More! If the av2 is being set up from its default state, the main left and right
speaker options will be limited to LG (large) until a sub-woofer has been
specified as present.
Pro Logic II options
av2
9.0 av2 detailed setup
nominate speakers