NanoCam Plus NCP-MIRDVRHD2 User Manual - page 11
11
2.7.3 Exposure
Exposure is used to manually control the light sensitivity settings. To change the
Exposure
setting follow the instructions below.
1.
Press the
Button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the
and Buttons to navigate the
Menu
and highlight the
Exposure
setting and press
to select.
4.
Use the and Buttons to highlight your desired
Exposure
, then press the
button to confirm your selection.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.4 Mute Audio
The Mute Audio setting allows you to mute the microphone during recording, or set it to record audio. To set your recording
preferences, please follow the instructions below.
1.
Press the
Button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the
and Buttons to navigate the
Menu
and highlight the
Mute Audio
setting.
4.
Press the
button to switch between ON and OFF.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.5 Date Stamp
Date Stamp will stamp the current date and time onto the footage for future reference. To set the date stamp please follow the
instructions below.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the Menu and highlight the
Date Stamp
setting.
4.
Press the
button to switch the setting between ON and OFF.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.