NanoCam Plus NCP-MIRDVRHD2 User Manual - page 8
8
2.3.2.2 Power Off
If the Mirror DVR is currently recording, please manually stop the recording by pressing the
button. Press and
hold the Power button on the front of the Mirror DVR. After powering off the device please wait for 10 seconds before
powering the Mirror DVR on again.
2.3.2.3 Reset the Device
If the Mirror DVR does not function normally, try restarting the Mirror DVR. Alternatively, to reset the Mirror DVR to factory
settings, press the small button (with a paper clip or other small object) on the rear of the Mirror DVR marked ‘
Reset
’.
2.4 Playing back video on a PC
To playback video files on your PC it is recommended that you connect the Micro SD card (not included) directly to your PC using
either a USB micro SD card reader (not included) or if your PC has an SD card slot, connect your micro SD card using a Micro
SD card to SD Card converter (not included). Once the SD card is connected it should appear as a removable storage device. It
is recommended that you transfer video files that you want to playback to a file on your computer before attempting to playback.
This will reduce any delay in playback.
2.5 Initial Settings
Before using the Mirror DVR we recommend
Formatting the Inserted Micro SD Card
and
Setting the
Time and Date
.
2.5.1 Formatting the Inserted Micro SD Card
Formatting the Micro SD card will delete all information on the inserted Micro SD Card and prepare the card for use with the
Mirror DVR.
1.
Press the
Button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and Buttons to navigate the
Menu
and highlight the
Format
setting.
4.
Press the
button to confirm the SD card format.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.
Formatting your Micro SD Card
will delete all files from the card. Once these files have been deleted you will not be able to recover them.
2.5.2 Setting the Date and Time
Setting the Time and Date allows you to stamp your footage with the time as a reference.
1.
Press the
Button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
Date
setting.