NanoCam Plus NCP-MIRDVRHD2 User Manual - page 14
14
3.1.4 Date Stamp
Date Stamp
is used to stamp your photos with the date and time they were taken. To select your preferred date and time
format follow the instructions below.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
Date Stamp
setting and press
to select.
4.
Press the
button to switch the setting between ON and OFF.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.
The
Date Stamp
setting is not used to set the cameras internal clock. To set the Date and Time, please see the
Date/Time
section of this manual.
3.2 Setting Menu
This menu is used to edit the Mirror DVR operational settings. This menu can be accessed by pressing and holding the
button
for 2 seconds while the Mirror DVR is idle and not recording. While in this menu the and buttons are used to navigate and the
button to select the highlighted setting.
3.2.1 Setting the Date/Time
Setting the Time and Date allows you to stamp your footage with the time as a reference.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
Set Date/Time
setting and press
to select.
4.
Use the and buttons to edit the selected digit and the
button to confirm and progress to the next field.
5.
To save the date and time and exit the menu, press the
button.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.
Once the time and date is set it can be stamped onto your footage using the
Date Stamp
setting. To configure Date Stamp setting, please refer to the Date
Stamp section of this manual.
3.2.2 Language
The Language setting is used to select your preferred Language in the menus. To set the language follow the instructions below.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the Settings
Menu
and highlight the
Language
setting and press
to select.