NanoCam Plus NCP-MIRDVRHD2 User Manual - page 9
4.
Press
to enter the
Date/Time
.
5.
Use the and buttons to edit the selected digit and the
button to confirm and progress to the next digit.
6.
To save and exit the date and time menu, press the
button
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.
Once the date and time is set it can be stamped onto your footage using the Date Stamp setting. To configure the Date Stamp setting, please refer to the Date
Stamp section of this manual.
2.6 Using the Mirror DVR
2.6.1 Recording Video
When the Mirror DVR is connected to your vehicles 12V DC power supply, the Mirror DVR will automatically power on and begin
recording when you start your vehicle. During the start up the buttons will be unresponsive and the camera will take a moment to
begin recording. The Mirror DVR will automatically stop recording and shutdown when your vehicle is powered off.
Note:
1.
Because of how some vehicles are wired, the recording may continue when the engine is switched off. If this happens, please manually turn off the Mirror DVR or
remove the charger from the cigarette lighter adapter or power source when not in use.
2.
The recording loop length can be configured to save a video file for every 1, 3 or 5 minutes of recording. For information on how to adjust this setting please refer
to the
Loop Recording
section of this manual.
3.
The device saves the recorded footage and photos on to the inserted Micro SD Card. If the memory card capacity is full, the oldest file in the memory card will be
overwritten.
2.6.2 Locked Recording
Locked Recording saves the current video file and protects it from being overwritten. To manually start a Locked Recording
follow the instructions below.
1.
During recording push the
button.
2.
To stop recording press the
button.
Note:
1.
If the
G Sensor (Gravity Sensing)
function is enabled and a collision is detected, the device will automatically trigger the emergency recording and protect the
current video file. Please refer to the section titled Gravity Sensing.
2.
The emergency recording file is created as a new file, which will be protected to avoid being overwritten by normal loop recording. If the inserted Micro SD Card
fills up with Emergency Recording files the message “SD Card Full” will appear on the screen, and the oldest emergency file will be automatically deleted when a
new emergency recording file is created.
9