NanoCam Plus NCP-MIRDVRHD2 User Manual - page 13
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
Image Quality
setting and press
to select.
4.
Use the and buttons to highlight your required image resolution, then press the
button to confirm your selection.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
3.1.2 White Balance
The
White Balance
setting is used to manually adjust the settings used to counteract different light conditions. This setting is
set to Automatic by default. To change the
White Balance
setting follow the instructions below.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
White Balance
setting and press
to select.
4.
Use the and buttons to highlight your required
White Balanee
setting, then press the
button to confirm your
selection.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
3.1.3 Exposure
Exposure is used to manually control the light settings. To change the Exposure setting follow the instructions below.
1.
Press the
button to stop the Mirror DVR from recording.
2.
Press and hold the
Button for 2 seconds to enter the
Menu
.
3.
Use the and buttons to navigate the
Menu
and highlight the
Exposure
setting and press
to select.
4.
Use the and buttons to highlight your exposure setting, then press the
button to confirm your selection.
Note:
1.
Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
13