NEC SL1000 User Manual - Placing Calls
- 1
-
Before using Your Telephone…
Thank you for purchasing NEC SL1000 system.
Due to the flexibility built into the system, your
Dialing Codes and Feature Capacities
may differ
from those in this guide. Check with your NEC Authorized Supplier / System Administrator and make a
note of any differences.
NEC Single Line Telephone(AT-45) is displayed here. This User Guide describes general analogue
Single Line Telephone (SLT) procedures. Refer to the User Guide included with to your specific SLT
for details on additional key functions.
Placing Calls
To change Trunk Access Code, Ask your NEC Authorized Supplier for details.
Listen for Dial Tone before dialing a Telephone Number.
For the Trunk Access Code, Ask your supplier for the details.
Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialing “1” changes voice/ring mode. (in case the destination is Multi-line Telephone)
Telephone Number
Extension Number
Place an Outside Call
Place an Intercom Call
Press REDIAL Key to automatically
redial the last number you dialed.
Flashes when you have Message
Waiting or there is an incoming call.
INDICATOR
REDIAL Key
While on a call, press FLASH Key to
hold the line.
FLASH (RECALL) Key
9
?
?
?
?
?
?
?
Trunk Access Code
HookFlash