Northern DVRN960 Series Setup Manual - page 6
6
Basic Setup
Enter the OSD main menu and setup some basic configuration of the DVR. The basic configuration
can be set via either the DVR or DVR
Remote
, the remote software.
Enter OSD Main Menu:
Press
MENU
to enter the OSD main menu.
Select the administrator account
“
admin
” to login. Enter
the preset password
“
1234
”.
It is strongly suggested to change the password to prevent unauthorized access.
Date
/
Time Setting:
Follow steps below to setup date / time before the recording starts. Refer to the User
’s Manual for
advanced setup of Time Sync function.
Select
Date
/
Time
> in System menu.
Select the date and time, and adjust the value with
UP
/
DOWN
keys.
The new date and time settings take effect after the changes are confirmed.
Language Setting:
If users wish to change language of the DVR system, follow the steps below.
Select
Language
> in System menu and press
ENTER
.
Press the
UP
/
DOWN
keys to choose the preferred language.
Network Setup
Configure the LAN setup for the DVR to properly function with Ethernet connection. The default IP
of the
DVRN960
must be changed to avoid network conflicts.
From the OSD main menu, select
System
>
Network Setup
>, set the
LAN Select
> item
to
LAN
>,
PPPoE
>, or
None
> according to the network application, and enter
LAN Setup
>.
For DHCP users, set the DHCP to
On
>. The IP address, Netmask, Gateway and DNS settings
are retrieved from network servers. DHCP is dynamic that the settings change from time to time.
For Non-DHCP users, set the DHCP to
Off
>. IP address, Netmask, Gateway and DNS settings
must be set. Please obtain the information from the network service provider.
To change the IP address, Netmask, Gateway and DNS value, press
UP
/
DOWN
keys to move
the cursor to the item. Use
LEFT
/
RIGHT
keys to access each section and press
ENTER
, then
change the value with
UP
/
DOWN
keys.
PPPoE users must set the
PPPoE Account
> and
PPPoE Password
> as well.
When complete the settings, press
ENTER
to confirm and save the settings; or, press
ESC
abort.