Novar ED&S Response PL4 Installation Manual - page 13
- 13 -
0
2
3
4
5
6
7
8
*
9
8
9
0
6
7
8
9
*
1
*
SECTION 4 – USING THE SYSTEM
★ Note: If you enter an invalid command or the command is incomplete, the Control Unit will
give a long, low-pitched beep (“error” tone). For valid commands, the Control Unit will
acknowledge acceptance with two short beeps, and if the command is related to one of the
four detection zones, the corresponding zone indicator will also flash once for confirmation.
4.1 User PIN
★ User PIN can disarm the system and change to OFF mode.
★ Two user PINs are allocated for this system.
Note: The factory setting for the User PIN is 1234 and 7890.
4.2 Changing the User PIN
★ User is highly recommended to change both of the PINs numbers when using it for the first
time. The User PIN is set to 1234 and 7890 at the factory and you may change them to any
four-digit numbers of your choice. The User PIN will be changed back to their respective
default values “1234” and “7890” if the power of the Control Unit has been reset.
With the system in “OFF” mode,
Change the 1
st
user PIN as follows:
Two short beeps indicate the command is successful and a long beep indicates the command is
rejected.
Change the 2
nd
user PIN as follows:
Two short beeps indicate the command is successful and a long beep indicates the command is
rejected.
4.3 Set / Clear chime Zones
★ The system can be set so that, when in “OFF” (Unset) mode, if a zone is triggered, the Control
Unit with give a chime tone. This can be done for any of the four zones.
With the system in “OFF” mode,
Set chime flag for any Zone as follows:
Two short beeps and the corresponding zone indicator flashes once to confirm.
Clear chime Zones as follows:
Two short beeps for confirmation.
Note: The chime Zone is Zone 1 at factory setting.
#
Default
New PIN NO.
1
#
Default
New PIN NO.
7
Zone No. (1~
~
~
~4)
#
*
1
#