Novar ED&S Response PL4 Installation Manual - page 14
- 14 -
2
*
3
*
4
1
#
4
2
#
4.4 Set /Clear
Home-Bypass
Zones
★ When the zone is set to Home-Bypass zone, the corresponding detector will not be activated
in HOME mode. However, when the system is put in “OUT” mode, the Home-Bypass zone
detector will be operative and, when triggered, will signal the Control Uint to alarm after 30
seconds (adjustable) delay time.
.
With the system in “OFF” mode,
Set Home-Bypass Zone for any of Zone 2 to 4 as follows:
Two short beeps and the corresponding zone indicator flashes once to confirm.
Clear Home-Bypass Zones as follows:
Two short beeps for confirmation.
Note: Zone 4 is set as Home-Bypass Zone at factory setting.
4.5 Set / Clear Bypass Zones
★ When a zone is set to Bypass Zone, the corresponding detector will not be activated in ANY
mode.
With the system in “OFF” mode,
Set Bypass Zone for any of Zone 2 to 4 as follows:
Two short beeps and the corresponding zone indicator flashes once to confirm.
Clear Bypass Zones as follows:
Two short beeps for confirmation.
4.6 Display Bypass Zones
With the system in “OFF” mode,
Check which zones have been set as Bypass Zones as follows:
Two short beeps and the zone indicators for the Bypass Zones will illuminate for a few seconds.
4.7 Display Zones with faulty devices
With the system in “OFF” mode,
Check which, if any, zone detector in the system has any problem as follows:
Two short beeps and the Zone indicator for any zone with faulty devices will illuminate for a few
seconds.
Zone No. (2~
~
~
~4)
#
*
2
#
Zone No. (2~
~
~
~4)
#
*
3
#
*
*
*
*
*
*
*
*