Novar ED&S Response PL4 Installation Manual - page 16
- 16 -
#
4.12 Clear the Alarm Hold Indications
★ To clear the alarm hold indications (illuminated zone indicators), do as follows:
With the system in “OFF” mode,
Key in the following buttons:
Two short beeps and all zone indicators turn off.
4.13 Panic alarm
★ Should you need to attract attention, the full alarm signal can be activated at emergency by
pressing * and # together.
Press & simultaneously, the system will sound immediately and all four zone
indicators will illuminate. The external sounder and the telephone dialer (if one is fitted) will be
triggered 30 seconds later.
4.14 Silencing the System
★ When the alarm is triggered, the user has to enter the PIN at the Control Unit to cancel the
alarm sound
and flash
.
★ If the alarm has not been cancelled, the alarm sound and flash will stop by itself after the
preset alarm duration timing (3 minutes at the factory setting, adjustable by user) and the
alarm hold indication (zone indicator) of the intruded zone will illuminate.
★ To clear the alarm hold indication; enter the PIN and the control panel will back to “OFF”
mode, then key in two short beeps and all indicators turn off.
4.15 Arm (set) the Alarm System while Exiting the House
Press “OUT” key for a while.
The count down warning sound (exit delay) will start and the “Zone 1” indicator will illuminate
while the entry/exit zone (zone 1) is opened.
Leave the house and close the door within the exit delay time (30 seconds at factory setting, user
adjustable). Both PIRs & Magnetic Switches are activated for protection after the exit time
expires.
Note: The system cannot enter OUT mode if zone 2 and/or 4 is triggered (Zone 2 and 4 indicators
illuminated).
4.16 Disarm (unset) the Alarm System while Entering the House
When you open the entrance door of zone 1, the count down warning sound (entry delay time) will
be on.
Enter your four-digit User PIN within the delay time (30 seconds at factory setting, user
adjustable). System changes to “OFF” mode (OFF mode status LED illuminated).
4.17 Arm (set) the Alarm System when you are Inside the House
Press “HOME” key for a while.
Both Magnetic Switches and PIRs are activated to protect your home except the Home-Bypass
zone.
You may set Home-Bypass zone for the areas where you will be in.
Note: The system cannot enter Home mode if zone 1 or 2 are opened.
*
*
*
*
*
8
#
*
#
8