Oki ML520 Instructions
1
Turn off printer and move the
paper lever to postion “TOP”
(1). Then open the access cover
(2).
2
1
1
1
2
58087102
Oki Data Americas, Inc., 2000 Bishops Gate Blvd., Mt. Laurel, NJ 08054-4620
TEL: (856) 235-2600
FAX: (856) 778-4184
www.okidata.c
om
© 1992, 2001 by Okidata
2
1
Cut Sheet F
eeder (C
SF) Instructions for M
L 5
2
0/5
2
1/5
90/5
9
1
ers
The Cut Sheet Feeder includes the
CSF unit (1), receive tray (2) and
sheet support (3). When it is
installed, you can still quickly and
easily switch to the continuous feed
path at any time.
Caution!
The printhead may be
HOT
!
2
Center the printhead (1) on the
platen, then grasp the pull-up
roller assembly (2) and pivot it
back to remove it.
3
Remove paper separator (1) and
set it aside for storage.
4
Hook the CSF brackets (1) over
the ends of the platen; push firmly
into place.
5
Plug the CSF interface
cable into the DIN
receptacle on the back of
the rinter (1), making
sure arrow on plug lines
up with arrow on printer.
6
Install the sheet support (1) for
the feed bin—ribbed side
facing the front of the printer—
on the square rod (2) at the
back.
7
Slide the receive tray (1)—
ribbed side facing front of
printer—into the channels
behind the metal frame.
8
Pull down the lock levers (1) on
the back of the CSF and set the
guides (2) to the correct
position for the width of the
paper you’ll be using. Push the
levers back up to lock them.
9
Push the CSF paper lever back to
the RESET position (1) and place
a stack of paper in the feed bin (2).
The CSF holds up to 100 sheets of
20-lb paper.
10
Pull the CSF paper lever
forward to the SET position
(1), then close the access cover
(2), leaving the carriage cover
(3) open.
1
2
1
1
1
2
1
2
3
1
1
2
1
3
2
11
Turn on the printer
(the printhead travels
back and forth, and
the SEL and POWER
lights come on) and
set the Top of Form
(see the back of this
sheet).