Oki Pacemark PM4410 Setup Manual - E-21
E-21
Pacemark 4410 Setup Guide
Load Paper
Front Feed Continuous Forms
Paper Specifications: Front Feed
Maximum thickness: 0.031 inches (0.79 mm)
Type
Weight
Width
Single Part
12 to 24 lb. (45 to 90 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
Carbonless
9 to 11 lb. (34 to 41 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
(1 + 9 max.)
Interleaf
9 to 14 lb. (34 to 52.5 g/m
2
)
3* to 16.5 inches (76 to 419 mm)
(1 + 6 max)
9 lb. (34 g/m
2
) carbon
Labels
0.011 inch (0.28 mm) thick
3¼ to 15 inches (83 to 381 mm)
Envelopes
24 lb. (90 g/m
2
) max.
3 to 10 inches (76 to 254 mm)
Card Stock
100 lb. (375 g/m
2
) max.
3 to 8 inches (76 to 203 mm)
* For paper widths less than 5 inches (127 mm), remove the support between the
tractors.
When using paper which is thicker than 7-part carbonless or
its equivalent, you must enter the Menu mode, then go to the
Impact Mode item in the Set-Up group and select High
Impact Copy as the setting.
To load front-feed continuous forms:
Preparation
1. Position the printer at the front edge of the support (this promotes the
unrestricted flow of paper into the printer), then place a stack of
continuous forms below the printer. Recommended height of printer
support, 29.5 inches (750 mm).