Packard Bell Easy DVD Recorder User Manual - page 42
Easy DVD Recorder User's Guide
40
Power cables
This equipment requires a 2-wire power cord. The cord length must not exceed 2.5 metres.
Replace the power cord if it gets damaged. Contact your dealer for an exact replacement. In
Europe, the plug must be rated for 250 VAC, 10 amp minimum. The plug must display an
international agency approval marking. The cord must be suitable for use in the end-user
country. Consult your dealer or the local electrical authorities if you are unsure of the type of
power cord to use in your country.
Batteries
Replacing Batteries
When replacing the batteries, use two batteries of the same type and manufacturer. Replace the
two batteries at the same time. Do not mix the use of old and new batteries.
When not using the battery for a long period (more than one month), remove the batteries to
prevent damage from battery corrosion.
In case the battery leaks, clean the liquid and install new batteries.
Battery Disposal
Ultimate disposal of the batteries should be handled according to all national laws and
regulations. Do not place used batteries in your regular waste: the incineration, landfilling or
mixing of batteries with the municipal solid waste stream is prohibited by law in most
countries. Contact your local waste management officials for other information regarding the
environmentally sound collection, recycling, and disposal of the batteries.
Chassis Cover Removal and Replacement
Before removing the chassis cover to service or modify the equipment, you must disconnect all
power cords. You then must close the chassis before you plug in and switch on the equipment.
Laser Compliance Statement
The optical devices are tested and certified to be compliant with International Electrotechnical
Commission IEC60825 and European EN60825 standards for Class 1 laser products.
Class 1 laser products are not considered hazardous. The optical devices are designed such that
there is never human access to laser radiation above a Class 1 level during normal operation or
prescribed maintenance conditions.
The optical devices installed in your product are designed for use solely as components of such
electronic product and therefore do not comply with the appropriate requirements of Code of
Federal Regulation Sec. 1040.10 and Sec. 1040.11 for COMPLETE laser products.
Because exposure to laser radiation is extremely hazardous, under no circumstances should the
user attempt to disassemble the laser device.