Panasonic KX-VC300 User Manual - Connect to The Internet
Connect to the Internet
To use KX-VC Series NAT Traversal Service, a network
environment and devices that meet the following
specifications are necessary.
Network Environment
To use KX-VC Series NAT Traversal Service to
establish video conference calls, a broadband
connection is required. (A 3-party video conference call
requires a 1.0 Mbps connection, and a 4-party video
conference call requires a 2.0 Mbps connection.)
Router
Please use a router that has been tested by Panasonic
for use with this service, and use the information from
your provider to connect to the Internet. For details
about tested routers, refer to the following web site:
http://panasonic.net/psn/products/hdvc/nat_traversal/
For details about configuring your router, refer to the
router’s documentation.
To connect the unit and router
1.
Connect the router to the LAN jack on the back of
the unit.
•
Connect a router to the LAN jack on the back of
the unit using a category 5 or greater LAN cable.
(The position of the LAN jack depends on the
unit that you are using. For details, refer to the
Operating Manual or User Manual.)
Note
•
Operation cannot be guaranteed in the
following cases:
–
You are using a router other than one tested
by Panasonic.
–
Multiple HD Visual Communication Units
are connected to one router.
–
The HD Visual Communication Unit is
connected directly to the Internet, and not
through a router.
Obtain a Registration Key
In this procedure, you will use a computer to access the
KX-VC Series NAT Traversal Service registration page
and obtain a Registration Key. The following
information is necessary:
•
MPR ID
–
This can be confirmed on the label on the back
of the unit or through operating the unit. For
details, see "To check the MPR ID (using the
•
Activation Key No.
–
Recorded on an Activation Key Card or an
Activation Key Sheet.
•
Registration ID
–
Recorded on an Activation Key Card or an
Activation Key Sheet.
To check the MPR ID (using the
unit)
1.
Press
[Menu]
.
•
The Menu screen is displayed.
2.
Use
[
][
]
to select
"Settings"
and press
[Enter]
.
•
The system settings screen is displayed.
3.
Press
[
]
twice.
•
The third page is displayed.
Document Version 2012-03
NAT Traversal Service User’s Guide
7
Setting up KX-VC Series NAT Traversal Service
Setting up KX-VC Series NAT Traversal Service