Protherm 100 Manual for instruction and use - page 4
6
7
The PROTHERM KLO boiler consists of
the following components:
1. cast iron body of the boiler with thermal
insulation and water connection pipe sec-
tion;
2. burner plate with gas connection route
and ignition device;
3. collector of combustion fumes with a
chimney thrust detector and SKKT ther-
mostat.
4. boiler covers with control panel and
boiler terminal box;
5. boiler base.
The cast iron boiler body is made of seg-
ments and serves as a combustion cham-
ber (including combustion fumes routes),
and also as a water reservoir (including
water routes). The segments are lateral
(right and left) and central (one kind). The
boiler body of the required size (including
combustion chamber and water reservoir)
is constructed by assembling and joining
together the segments. The assembled
boiler body is fitted with pipe sections for
water connection and is insulated against
heat loss and heat radiation. It also has
960
850
52
544
92
125
370
605
720
1
195
A
B
75
111
Æ
G 6/4"
G 1"
Æ
G 6/4"
C
Æ
D
770
objemový prùtok vody V (m /h)
3
tlaková
ztráta
p
(Pa)
20000
18000
2
0
0
4
6
8
10
12
16000
14000
12000
10000
8000
6000
4000
2000
65, 85 KLO / KLO EKO
100 KLO / KLO EKO
130 KLO / KLO EKO
150 KLO / KLO EKO
Model
65 KLO /
KLO EKO
85 KLO /
KLO EKO
100 KLO /
KLO EKO
130 KLO /
KLO EKO
150 KLO /
KLO EKO
A
850
1010
1170
1410
1570
B
460,5
540,5
620,5
740, 5
820,5
C
860,3
850,3
840,3
825,3
825,3
D
180
200
220
250
250
brackets for fitting thermostat sensors and
a thermometer, and lugs on feet for con-
necting the body to the boiler base. The
KLO EKO series boilers use low-emission
burner tubes, the KLO series boilers use
standard tubes. Depending on the output,
the boiler has 7 to 16 burner tubes and a
complete gas route.
The burner plate is fitted with a gas dis-
tribution section, the actual burner tubes
and an ignition device. The gas route
consists of a gas supply pipe section ter-
minated with a combined gas valve. The
combined gas valve controls the supply
of gas into the boiler depending on the
required and reached operating states of
the whole system (i.e. the boiler combined
with the heating system); its outlet is al-
ready the gas distribution section of the of
the burner plate, terminated with 7 to 15
jets (one for each burner tube).
Igniting the burner and watching that it is
running is done by a Polidoro low-emis-
sion ignition burner. When a request is
sent to ignite the main burner, after waiting
time T
w
= 10 seconds, the ignition burner
Accessories
Pressure loss (P
a)
Fig. 1
Basic and Connecting Dimensions
Pressure loss of the boiler´s body
Fig. 2
Flow of water volume V (m3/h)