Quadra-Fire 5100 ACC Installation Manual - page 21
October 14, 2013
7047-910
21
5100 I-ACC
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Figure 21.1
Thermal
Protection
Decorative tile may
be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Figure 21.2
Figure 21.3
Figure 21.4
PartNo.841-0990,size9”x45”and
Part No. ADJSPT-12, size 12” x 50”
H. Zero Clearance Adjustable Trim Support,
2” to 10”
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim
Sides,Double-SidedTape(alreadyinstalled)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal
Shears,MeasuringTape,Gloves
1.The 10 screws on each set of scissors will already be
loose when shipped.
Figure 21.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips Head screwdriver.
Figure
21.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from topoftrimsedge,notbottom.Thisedgewill
be sharp; wear gloves to prevent injury to your hands.
Figure 21.2.
4. Using sheet metal shears, cut trim along the marked
edge.Thecutedgefitsunderlipoftoptrim,soitallows
for some variance in your straight edge.
5.Thedouble-sidedtapethatholdsfrontandsidetrimsto
scissors has a particularly powerful bonding adhesive.
Adjustmentsareextremelydifficultoncetrimhasadhered
totape.Doadryrunfirstwithoutremovingpaperfrom
tape.
6. Place cut edge of trim under top lip and into position on
scissors.Placesidepiecesonfirstandthenfrontpiece.
Thefrontpieceoverlapssidepieces.
NOTE:Thetrimin
the Flush Mount Kit is one piece.
7.Onceyouaresatisfiedwiththepositioning,removetrim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. Thereare3holesinthebackflangeofthetoptosecureit
to the wall if necessary. Use the appropriate fastener for
the type of wall material, i.e., brick, sheetrock, etc.
NOTE:3/8”(9.5mm)thick tile or like material can be cut
tosizeandfitunderlipoftoptrimedgeforadecorative
touch.
Figure 21.3.
10.Thermalprotectionof1-1/2inches(38mm),“k”valueof0.49
and R value of 3.06 under the zero-clearance trim support.
Figure 21.4.