Quadra-Fire MTV-E2-CSB Installation Manual - page 18
18
7080-131B
March 14, 2014
MT VERNON E2
3 in. to 6 in.
Offset Adapter
Silicone Rear
Exhaust Outlet
3 in. to 3 in. Top
Vent Adapter
Clean-Out
Cover
Drill Hole, 1
on each side
C. Top Vent Adapter Installation
3 to 3 inch (76-76mm) Top Vent Adapter
3 to 6 inch (76-152mm) Top Vent Offset Adapter
Installing the Top Vent Adapter
1. Put a layer of high temperature silicone on the 3 inch
(76mm)exhaustoutlet.
Do not put silicone inside of
pipe. Figure 18.1.
2. Slidethetopventadapterontotherearexhaustoutlet
andadjusttheassemblytoaverticalpositionuntilthe
topoftheflueoutletiscenteredandisinalevelposition.
Figure 18.1.
3. Alignslotonleftofadapterwithholeinthebackofthe
unit and secure with screw. You may drill out the hole
using#26drillbitprovidedbutonlyifneeded.
Figure
18.2.
4. Install the 5 mounting screws, 3 on the left and 2 on the
right.
5. Drill2holeswith#26drillbitthroughtherearexhaust
outlet using the 2 holes already in the short horizontal
pipeinthetopventadapterasaguide.Installthescrews.
6. Installtheventpipeintothetopventadapter(besure
tosiliconealljoints).Touseanexisting6inch(152mm)
vent system, install the 3 to 6 in (76-152mm) offset
adapterbeforeinstallingventpipe.
7. To clean top vent adapter, open clean-out cover and
removeanydebrisbuild-up.
Figure 18.2.
Figure 18.2
Figure 18.1
D. Rear Vent & Rear Vent to Top Vent Adapter
Installation
Clean-Out Cover
Clean-Out Cover
Figure 18.3 - Rear Vent Adapter
Figure 18.4 - Rear to Top Vent Adapter - 90
o
1. Put a layer of high temperature silicone on the 3 inch
(76mm)exhaustoutlet.
Do not put silicone inside of
pipe. Figure 18.1.
2. Slidetheadapterontotherearexhaustoutletandadjust
theassemblytotheappropriateposition.
3. Installtheventpipeintotheadapter(besuretosilicone
alljoints)