Quadra-Fire MTV-E2-CSB Installation Manual - page 20
20
7080-131B
March 14, 2014
MT VERNON E2
F. Remote Thermostat Installation
1. Whenmountingthethermostatonthewall,besureto
followyourremotethermostat’sinstallationinstructions
carefully.
NOTE: The remote thermostat should be mounted
on an inside wall and not in direct line with the ap-
pliance convection air.
NOTE: If the remote thermostat is located too close
to the appliance, you may need to set the tempera-
ture setting slightly higher to maintain the desired
temperature in your home.
Photo of Thermostat separated from its docking station
below:
Shock hazard.
• DoNOTremovegroundingprongfromplug.
• Plugdirectlyintoproperlygrounded3prong
receptacle.
• Routecordawayfromappliance.
• DoNOTroutecordunderorinfrontofappliance.
CAUTION
Tools Needed:
Phillipsscrewdriver
Power Drill
1/4”or7/64”drillbit
Tape Measure
Detachtheremotethermostatfromitsdockingstationby
pulling them directly away from each other.
Usingthefastenersand(ifneeded)anchors–included
withtheremotetransmitterpackaging–fastenthedocking
station to the wall.
IMPORTANTNOTES:
Forbestapplianceperformance,positionthedocking
stationat60inchesheightfromthefloor,nofurtherthan20
feet from the appliance, out of direct sunlight, and out of the
directflowofconvectionaircomingfromtheapplianceor
structure’sHVACdischargeair.
For instructions on thermostat function and interaction with
theappliancerefertotheowner’smanual.
G. Power Cord
1. Prior to installing the power cord, turn the dial control
“OFF”.
2. Makesurethewallreceptaclehas120vacoutput.
NOTE:Usingacircuitprotectorcanprotecttheappli-
ance circuits from power surges.
3. Theappliancerecepticalislocatedonitslower,back
right hand corner. Install the cord to wall and appliance
reception.
4. Refertoowner’smanualforapplianceoperation.