RabbitLink EG2110 User Manual - page 12
Manual is about: Network Programming Gateway
of
50
8
RabbitLink (EG2110)
2.
Connect the programming cable
You must connect the programming cable to configure network parameters from your PC.
Connect the 10-pin
DIAG
connector of the programming cable to header J8, which is labeled
PROG IN
, on the RabbitLink. Ensure that the colored edge lines up with pin 1 as shown. Con-
nect the other end of the programming cable to a COM port on your PC.
Figure 2.1.0-2 Programming Cable Connections
Flash
EPROM
Flash
EPROM
90
15
65
SRAM
Colored edge
down
DIAG
PROG
Programming Cable
J9
PROG OUT
IN
PROG
J8
To
PC COM port
DIAG