RabbitLink EG2110 User Manual - Ppendix
User’s Manual
33
A
PPENDIX
E. S
ERIAL
C
ONSOLE
C
OMMANDS
This appendix describes the RabbitLink serial console commands. The serial console was
designed to be human-accessible as a convenient way to setup the network configuration. It is pos-
sible to use these commands programatically from the target, though it is not recommended. If
Internet services are desired, Z-World suggests the DeviceMate software, which may be run on the
RabbitLink board.
E.1 Configuration Commands
These commands are used to set network parameters and to password protect the RabbitLink.
set gateway
This command sets the IP address for the gateway.
IP address
The IP address for the gateway in dotted decimal format. The factory
default is
10.10.1.1
.
set hostname
This command allows the RabbitLink to be identified with a unique name, that may be up
to 40 characters long.
name
User-chosen string. The factory default is
RabbitLink
.
set ip
This command sets the IP address for the RabbitLink.
IP address
The IP address for the RabbitLink in dotted decimal format. The factory
default is
10.10.1.100
.