RabbitLink EG2110 User Manual - page 29
Manual is about: Network Programming Gateway
of
50
User’s Manual
25
3. Attach the enclosure top to the base.
Position the enclosure top over the plastic enclosure base as shown below in Figure B.1-3.
Attach the enclosure top to the base using the two 4-40 × ½ screws supplied. If you installed
the light pipes, be sure they are aligned over the LEDs as shown.
Figure B.1-3 Attach Enclosure Top
4. Mount plastic enclosure (optional).
Use four #10 screws to attach the assembled plastic enclosure to the surface on which it will
be mounted. This step applies to production versions of RabbitLink boards once development
has been completed.
SRAM
Notched
side
90
15
65
FlashEPROM
FlashEPROM