RADVision Scopia XT1000 User Manual - page 26
RADVISION | User Guide
First Time Equipment is Switched On
| 26
First Time Equipment is Switched On
You can connect to the system one monitor (to the HD1 Output), or two (one to the HD1
Output, one to the HD2 Output). In any case the system is able to automatically recognize
the output configuration, and properly working.
To change default settings, see the I/O Connections section.
ONE Monitor Configuration
When not connected, you’ll see the GUI overlapped to the local camera image. Once in
connection, you’ll see two overlapped images: the remote image in full-screen format, and
the local image in a smaller overlapped window (PIP, Picture In Picture).
By pressing the layouts key on the remote control, you can swap the contents of the
windows: you’ll see the local image in full-screen format, and the remote image in a
smaller overlapped window.
By pressing the pip key, you can change the visualization to two windows of the same size
(PaP, Picture and Picture) or remove the second window.
If the remote sends you a presentation, you’ll see it in full-screen format, with the remote
image in a smaller overlapped window. By pressing in sequence the layouts key on the
remote control you can change the contents of the windows, choosing to see the
presentation, remote video or local video as the full-screen content.
The pip key on the remote control acts as before.