RADVision Scopia XT1000 User Manual - page 42
RADVISION | User Guide
System Configuration Settings
| 42
System Configuration Settings
This section describes the procedures to properly configure the system.
Important
Some configuration parameters have been set the first time the system was
switched on; some other can be applied only when no connection is active.
From the home page select Settings. Three choices are available:
User settings– press the YELLOW function key on the remote control.
Administrator settings – press the RED function key on the remote control.
Quick Setup – press the BLUE function key on the remote control to come back to the
setup wizard.
User Settings
User Preferences
This menu contains the following configuration settings:
Language to set the interface language.
Automatic screensaver to enable screensaver function (with its activation time).
Remote control code. The remote control has a code (01 by default) that can be