RADVision Scopia XT1000 User Manual - page 44
RADVISION | User Guide
System Configuration Settings
| 44
Load Default Values
To restore all default values for user settings, you will be asked for confirmation.
Administrator Settings
You need a password to access the administrator settings. The default password is 1234.
You may change the password in Administrator settings->Utilities ->Password.
Note:
Some settings have already been covered in the Quick Setup section, because
they belong to the minimal required set necessary to have system properly
working. In any case they can be modified in this menu.
System
This menu contains the following configuration settings:
Date – time
Location
LDAP
Date - Time
Use this menu to directly set date and time values, or to enable and configure NTP server
(internet Time).
Note:
The NTP server (Network Time Protocol) allows you to synchronize your system
clock to the clock in the network, allowing you to align with precision devices
connected on the Internet.