RADVision Scopia XT1000 User Manual - page 36
RADVISION | User Guide
Call Management
| 36
Secure Connections
The system can manage secure videoconference sessions via encrypted connections, in both
point-to-point and multipoint sessions. The multipoint session supports up to three remote
encrypted participants.
To do this, the encryption function must be enabled: for more information, refer to the
Encryption section of this guide.
Once encryption is properly configured, you can make a secure call by following the same
procedure described for a standard call.
Useful Information
The encryption status can be checked on the local information area.
If the encryption is enabled and configured, an icon showing a padlock is displayed; the
padlock icon meanings are:
Encryption has been enabled but the function is not active.
Encryption is active.
Encryption is activated in transmission only.
How To Receive a Call
If you receive a call and the automatic answer function is not enabled, or you are in a
configuration page, a notification will be displayed and you will be prompted whether or
not to accept the call.
Presentation
Once a call has been established, you can send to the remote terminal a second video
stream with the PC content (obviously having a PC connected to the DVI system input): to
do this, simply press the Presentation key on the remote control.