Rangemaster CLASSIC 110 GAS FSD User Manual - page 22

22

Fit  the  Handles

Remove the 4mm Allen screws from the doors with 

the hexagon key tool. Use the screws to fit the door 

handles. 

The handles should be above the fixings.

Remove the 4mm Allen 

screws from the top corners 

of the fascia and fix the front 

handrail in position.

Fitting  the  splash  back 

(optional)

Remove the two fixing screws (3mm hexagonal socket 

head) and nuts that pass through the top of the rear 

flue grille. Hold the splash back in position. From the 

rear refit the 2 fixing screws and nuts.

Fitting  a  stability  bracket

A stability bracket or chain (

not supplied by with the 

cooker) should be fitted when the cooker is connected 

to a flexible gas supply. 

When fitting a stability bracket read these instructions 

together with the leaflet supplied with the bracket.

1.  Place the cooker in its intended position and level the 

cooker.

2.  Draw a pencil line 100mm from the front edge of the 

levelling feet.

3.  Mark the centre line for the bracket by measuring 

550mm from the left hand side of the cooker.

4.  Lower the front roller and move the cooker forward.

5.  Measure back from the pencil line 550mm to locate 

the front edge of the bracket. Fix the bracket to the 

floor.

6.  Measure the height from floor level to engagement 

edge in back of cooker. Add 3mm to this dimension 

and assemble the stability bracket to this height. (i.e. 

from floor level to underside of the top member) and 

ensure the bracket does not foul the oven burner 

assembly.

Gas Connection

view from the rear

The Gas supply needs to terminate with a down facing 

bayonet. The rear cover boxes limit the position of the 

supply point.

Because the height of the cooker can be adjusted and 

each connection is different it is difficult to give precise 

dimensions. Ideally the house supply bayonet should 

be in the shaded area shown in the diagram. Although 

a 900mm hose can be used, a 1250mm hose will allow 

slightly more flexibility in the positioning of the bayonet 

and make moving the cooker easier. The hose should 

be fitted so that both inlet and outlet connections are 

vertical so that the hose hangs downwards.

The connector is located just below the hotplate level 

at the rear of the cooker.

The inlet connection on the cooker is ISO 7-1 

internal. If you require a ISO 228-1 connection, find 

the ISP 228-1 connector in the top pack. Apply a 

suitable thread sealing compound to the ISO 7-1 end.

Screw the connector into the cooker inlet until it is 

finger tight. Using two suitable tools, one on the inlet 

on the cooker to make sure it is held steady and one 

on the connector, tighten the connector into the inlet 

on the cooker.

Minimum torque 12Nm.

Maximum torque 20Nm.

Connect the hose to the connector.