Version 1.00 page 1 of 12 installation example and guide author: road angel group date: may 2016 version: 1.00
Version 1.00 page 2 of 12 contents contents ..................................................................................................................... 2 introduction ............................................................................................................. 3 scope ........
Version 1.00 page 3 of 12 introduction this document provides a method for a typical installation of the road angel halo device. Using the recommendations within this document will help improve installations, provide a more reliable product and promote a better customer experience. We recommend that...
Version 1.00 page 4 of 12 location it is recommended to install the primary halo device around the top/centre of the windscreen near the rear view mirror, ensuring driver visibility is not obscured, while ensuring any leads are not subjected to stress once connected to the unit. Find a suitable loca...
Version 1.00 page 5 of 12 step 2: rear camera installation: when installing the rear camera, it is recommended that this item is fitted at the upmost point of the rear windscreen, with the lens directed towards the back of the vehicle/road. Before fitting the rear camera, take note of the white arro...
Version 1.00 page 6 of 12 note: some materials used for vehicle trim/lining may be brittle in cold conditions. It is recommended that the vehicle is exposed to warm conditions prior to applying any level of stress, reducing the risk of damage. Step 3: connecting the primary device (front camera): on...
Version 1.00 page 7 of 12 remove the cover from the fuse box. In most cases, cables running from the fuse box can be used for the source of the ignition feed. Using the appropriate tool, fit both the power cable and extension lead in a cavity behind the lining above the windscreen and behind the veh...
Version 1.00 page 8 of 12 step 5: hardwire lead – installing a live connection: locate the white “b+” wire found on the halo hardwiring lead. Remove the excess plastic sheath material to expose the cable. This exposed cable will be connected to the vehicles live connection. Locate a positive (perman...
Version 1.00 page 9 of 12 wrap the exposed cable of the halo “acc” wire around the exposed area of the vehicles ignition feed several times securing the connection. In order to further secure this connection, it is recommended that these cables are soldered together and protected with adhesive elect...
Version 1.00 page 10 of 12 step 5: completing the installation: ensure the fuse box housing is thoroughly re-secured in the default position and no bare cables are exposed and return the cover of the fusebox. Verify the halo sd card is installed in the device and start the vehicle ignition. Within 6...
Version 1.00 page 11 of 12 cabling and hardwire installation the supplied 12v power lead is used for a normal ‘plug & play’ installation and is connected directly to the cigar socket / dc out connection. When hardwiring a halo device, this cable is redundant. However, we recommend connecting the hal...
Version 1.00 page 12 of 12 placement of the all cabling should be kept away from air bags or similar safety equipment, away from door wells or moving parts where it could interfere with their operation or sever the cabling. When installing the cables, avoid obscuring field of view, vents or breachin...
