Road Angel Halo Installation Example And Manual - page 9
Version 1.00
Page 9 of 12
Wrap the exposed cable of the Halo “ACC” wire around the exposed area of the vehicles ignition feed
several times securing the connection. In order to further secure this connection, it is recommended that
these cables are soldered together and protected with adhesive electric tape.
Note: The Halo hardwire lead includes a fuse on the live connection. It is recommended to install a
further inline fuse on the ‘ignition’ (ACC) lead. However, the Halo device does not rely on this ACC lead
for power and this is simply ‘good practice’ and should be a decision for the installer.
Step 5: Hardwire Lead
– Installing the ‘Earth’ Connection:
Locate the black “GND” wire found on the Halo hardwiring lead. This lead is used to ‘ground’ the
device and complete the circuit to the negative terminal of the battery.
The vehicle chassis should allow a point to ground the device.
The GND cable supplied can be attached directly behind a screw point of the vehicle chassis.
However, in some instances it may be more practical to using a self-tapping screw, directly into the
chassis near the fusebox, which may reduce the length of cable required allowing for an uncluttered
finish.
Note: It is important to ensure a clean connection to the chassis to ensure a true ground (-) connection.