Road Angel Halo Installation Example And Manual - page 7
Version 1.00
Page 7 of 12
Remove the cover from the fuse box. In most cases, cables running from the fuse box can be used for
the source of the ignition feed.
Using the appropriate tool, fit both the power cable and extension lead in a cavity behind the lining above
the windscreen and behind the vehicle trim until the cable reaches the exposed fuse box.
At this stage, it is likely that there will be excess cable remaining. Wrap the excess cable neatly, allowing
enough length on the hardwire cable to be connected inside the fuse box.
Step 4: Hardwire Lead/Connections:
In order to correctly connect the Halo device to the vehicles electrics, it is important to pay attention to
the function of each of the 3 cables present on the Halo Hardwire lead.
B+
(“Battery-Positive” cable)
ACC
(“Ignition Switched” cable)
GND
(“Ground” cable)
For
more detailed information, please refer to page 5 of the “HALO Installation Guide for Installers”
(Version 1).
It is highly recommended that only a qualified auto-electrician performs modifications to vehicle electrics
to avoid damage.