Road Angel Halo Installation Example And Manual - Location
Version 1.00
Page 4 of 12
Location
It is recommended to install the primary Halo device around the top/centre of the windscreen near the
rear view mirror, ensuring driver visibility is not obscured, while ensuring any leads are not subjected to
stress once connected to the unit.
Find a suitable location for the Halo within the vehicle where the primary unit has a clear forward facing
view. Both the power connection and rear camera extension cable must reach the Halo device without
compromising safety or obscuring visibility of both the driver and device lens.
It is recommended to install the rear camera around the top/centre of the rear windscreen where the unit
has a clear rear facing view. Once again, the cabling and extension leads should not be subjected to
stress.
Step-by-Step Instructions
In most cases it is practical to begin the installation of the Halo device by fitting the rear facing camera
first, allowing any excess cabling to be concealed within the dashboard bulk space of the vehicle.
This allows a professional finish and provides excess cable towards the front of the vehicle should there
be a need to refit/modify the cable in the future.
Step 1: Rear Camera Connection:
Given that in many installations the rear of the vehicle may be troublesome to access, it is recommended
that the cable extension lead is connected and secured to the rear camera first, before installing the rear
camera.
In order to prevent unintended disconnection during fitting; it is recommended to use adhesive electric
tape, securing the extension lead and rear camera before applying the camera.