Road Angel Halo Installation Example And Manual - page 10
Version 1.00
Page 10 of 12
Step 5: Completing the Installation:
Ensure the fuse box housing is thoroughly re-secured in the default Position and no bare cables are
exposed and return the cover of the fusebox.
Verify the Halo SD card is installed in the device and start the vehicle ignition. Within 60 seconds an
LED should appear at the rear of the device followed by an audible alert.
Allow the device to record for a few minutes before switching off the ignition and disconnect the power
cable directly from the device to prevent data loss, before removing the SD card.
It is highly recommended at this stage to check the footage on the SD card using the supplied Halo
software and player, followed by altering the angle of both the front and rear camera lens to desired
position.