Road Angel Halo Installation Example And Manual - Introduction
Version 1.00
Page 3 of 12
Introduction
This document provides a method for a typical installation of the Road Angel Halo device. Using the
recommendations within this document will help improve installations, provide a more reliable product
and promote a better customer experience.
We recommend that you review the Cabling and Hardwire Installation and Cable & Connector Stress
prior to any installation (page 11 & 12),
It should be noted that this installation example is to provide the basis of a typical installation. As each
vehicle will differ in layout, the process of installation may differ significantly.
This document intends to provide a step-by-step guide for installations but may not be an applicable
approach for all vehicle types.
All installations are governed by the FCS1362:2010 UK Code of practice for the installation of
mobile radio and related ancillary equipment in land based vehicles. All installers are expected to
adhere to the FCS1362 standards as a minimum.
Scope
This guide covers the fitting requirements for an installation into a 12v or 24v vehicle and relates to the
following unit variants:
Hardwiring can be performed by any auto electrician trained in 12v installation, familiar with modern
vehicle assembly methods and the ability to dismantle trim panels with the care and sensitivity that
vehicle plastics require.
Items Required for Hardwire Installation
Items sold separately
Halo hardwire lead* (DC power in)
Configuration:
o
12v DC socket to device.
o
Positive (Fused), Ground and Ignition switched leads.
*Note: 3
rd
party leads/connections are not supported and may compromise device warranty.
Required for installation
(in box)
Halo - primary device (forward facing camera)
Rear camera
Rear camera extension lead
Adhesive wire clips
Additional items
(in box)
12v DC power lead - cigar socket connection (plug & play only)
Micro SD card
Micro SD card reader (USB)
USB stick (containing Halo software & user guide)