Road Angel Halo Installation Example And Manual - page 5
Version 1.00
Page 5 of 12
Step 2: Rear Camera Installation:
When installing the rear camera, it is recommended that this item is fitted at the upmost point of the rear
windscreen, with the lens directed towards the back of the vehicle/road.
Before fitting the rear camera, take note of the white arrow symbol located at the back of the camera.
This white arrow should be pointing upwards, with the cable protruding from the left side of the camera.
Remove the film from the adhesive pad and firmly attach the rear camera, making adjustments to the
camera lens position by rotating the cylinder to the desired angle.
Typically a 90
– 110 degree angle of the lens should provide the best image capture, depending on
preference.
Note: it is recommended to review the footage of the rear camera post-installation and adjust the
position of the rear camera to the desired angle.
Step 3: Wiring Placement (Rear Camera):
While each vehicle is different, the approach is often similar. In order to promote a discrete installation, it
may be desirable to conceal the rear camera cable and extension cable from sight.
The cable should be fitted from back to front, running the cable along the driver’s side until the extension
cable reaches the fuse box. In order to do so, the appropriate tools should be used to carefully expose a
cavity in the roof lining. A plastic trim tool is ideal. Gently pry the lining from its base allowing just
enough room to obscure the cable from sight and re-apply the lining once the cable is concealed.
The example (left image) shows the wiring is concealed within the break light cover found at the top
centre of the rear windscreen. This may not be applicable to all vehicles.