SmartSight S1000-RX 1 User Manual - page 12
6
starting normally. Power down and power back-up the module once. If the
condition persists proceed to a firmware upload (see CHAPTER 6) and if this fails
or the condition persists after the new upload, call SmartSight technical support
to obtain an RMA authorization.
____________________________________________________________________________
Tx After Power-up:
Flashing Green (steady rate) if not communicating with another module.
Flashing Green (various rate) if system communicating.
Flashing Green with intermittent Red flash if the radio link is not very good
and there are video frames lost.
Rx After Power-up:
Steady Green (if not communicating with another module).
Flashing Green (various rate) if system communicating.
Flashing Green with intermittent Red flash if the radio link is not very good
and there are video frames lost.
___________________________________________________________________
When communication is established between the transmitter and receiver, the GREEN LED flashing
rate is an indication of the number of frames transmitted every second. If the link is very good
the rate will be high. Under poor link conditions, the system will retransmit video frames constantly
and the frame rate will decrease as a result. If there are too many retransmission of video frames
some video frames may be lost and the picture quality may degrade momentarily (a flashing RED
LED indicates this state).
___________________________________________________________________
3.3 S1000 system installation
STEP 2 Installing the S1000 system in it’s final location
• Once your system is successfully configured it is ready to be installed
• Carefully review the site planning information presented in CHAPTER 4 to
optimize your system radio performance.
• If installing the S1000-TX on a light pole or mast, we suggest you use the
S1000-PM pole mount brackets and stainless steel clamps (for wall
mounting use the module side brackets).
• ALWAYS mount the S1000 modules with the industrial bayonet type black
connector pointing downwards.
• Connect the S1000-CA-9P cable assembly to the S1000 module and route
the cable to the dome or camera (all connections for the S1000-24VAC
model can be made inside a dome or motorized camera if 24 VAC is being
used for these devices). If the S1000-JB interconnection box is being used,
route all conductors to the S1000-JB first and then route all conductors from
the S1000-JB to the dome or camera).