SmartSight S1000-RX 1 User Manual - page 30
24
Figure 11
Screen shot before a firmware upload
STEP 2. If you are not using your computer’s COM1 serial port (the default port
used by the SMI program after installation), you will have to select the
correct serial port number on your computer by choosing the
showed in ‘Figure 12’ will appear.
Note: Once you have launched SMI once, the next time you start the
program it will use the last COM port selected and point to the last file
uploaded.
____________________________________________________________________________
If you have installed a PDA synchronization program on your computer such as Palm
HOTSYNC
TM
and it is using the COM port (not a USB or Infrared port) , you will first need
to disable this program if it is active. Failure to do so will prevent the SMI program from
opening the COM port..
____________________________________________________________________________