SmartSight S1000-RX 1 User Manual - page 25
19
SmartSight
TM
1000 User Manual / Rev 0.33
Figure 8 Hyper Terminal
configuration
window
____________________________________________________________________________
If you have installed a PDA synchronization program on your computer such as Palm
HOTSYNC
TM
and it is using the COM port (not a USB or Infrared port) , you will first need
to disable this program if it is active. Failure to do so will prevent you from successfully
using the COM port to configure the S1000 system.
____________________________________________________________________________
5.3 S1000 CLI
5.3.1 Starting
the
CLI
Now that Hyper Terminal is started, you have to start the SmartSight 1000 CLI.
On the keyboard
- Press ‘Ctrl-Break’ simultaneously, wait 1 second and then press the ‘Space’ bar.
The SmartSight 1000 CLI menu should appear as seen in ’Figure 9’