SVS-Vistek evo1050 Operation Manual - page 14
2 Getting Started | 7
Install the camera in the desired location:
To mount the camera use the supplied tripod adapter or the the four
M3 holes located on the camera front plate.
Connect a Camera Link cable to your frame grabber.
Connect the Camera Link cable to connector A of the camera (see
drawing). In case you take advantage of the full speed of the camera,
connect two CL cables. The cable should not be longer than 10 m
when running camera with more than 64 MHz. (A “Repeater” is available
to extend cable lenghth. Consult your local distributor.)
Connect the power supply to the camera.
Connect the power supply to main voltage.
NOTICE
if you have ordered a power supply connect the 12-pin
Hirose connector on the camera. if you use your own
power supply, it must be 12 V and have the appropria-
te mating connector with 10 – 25 V.
2.4 Installation