SVS-Vistek evo1050 Operation Manual - page 30
4 Software Control | 23
The “Analog Control” Folder
”Tap Selector“:
Select the tap for the “Gain” and “Black Level”
configuration:
“TapAll”: gain and black level can be configu-
red for all taps simultaneously.
“Tap0”,”Tap1”,”Tap2”,”Tap3”: gain and black
level can be adjusted for only one tap, useful
for manual tap balancing.
“Gain”:
Gain can be configured for the selected tap
(see above).
The default gain setting is 0.0 dB (factor 1.0).
You may change the gain up to 18.0 dB (factor
8.0) in steps of 1/10th dB. Note that the
dynamic range will not be improved! For good
image quality do not set gain to more than
6.0dB (factor 2.0), because the noise is also
amplified.
“Black Level Raw“:
Black level offset adjustment is possible for the
selected tap (see above). Please note that fac-
tory adjustment is optimized for S/N ratio and
sensitivity at gain 0 dB. You may lose dynamic
range if the black level is set to high or to low.
“Tap Balance“:
Select the tap balance operation:
“TapBalance_Off”: no tap balance operation
“TapBalance_Once”: taps are balanced until
they match, then operation stops. The configu-
ration is kept until camera is switched off
“TapBalance_Continuous”: taps are balanced
permanently during image acquisition.
“TapBalance_Reset”: balancing of the taps is
reset to factory default values.
1
2
1
3
4
2
3
4
The “UserSet Control” Folder
“User Set Load”
if you have troubles during configuration, you
can reset the camera to the last saved configu-
ration clicking this button. Click on “Refresh”
button afterwards to update the user interface
(you could also switch camera power off and
on and then click on “Refresh” button).
“User Set Save”
if you have configured your camera successful-
ly you can save the actual configuration in the
EEPROM of the camera. Every time the camera
is connected to power it will start with this con-
figuration. Ensure that your camera is running
correctly before you click this button!
“Factory Set Save”
This saves the factory default values to EE-
PROM. The button is only used during first run
after production of the camera. Ensure that
your camera is running correctly before you
click this button!
1
2
3
1
2
3