Tally T6215 Maintenance Manual - page 105
4–35
Chapter 4: Removing and Replacing Components
Procedure 17: Paper Drive Motor Removal
Step 1. Remove the Ribbon Platform (see Procedure 1).
Step 2. Tilt the Print Mechanism (see Procedure 10).
Step 3. Loosen the screw holding the lower idler bracket and slide it away from the
belt, then retighten the screw to hold the bracket in place temporarily.
Step 4. Loosen the three screws holding the paper drive motor to the side frame
plate.
Step 5. Remove the two drive belts from the pulley on the motor. Unplug the motor
from the Platen/Paper Sensor CBA.
Step 6. Remove the three screws holding the motor, then lift the motor out of the
frame.
Step 7. After the motor is reinstalled, leave the mounting screws slightly loose, then
perform the Phasing and Belt Tensioning Adjustments (see Procedure 14).
Orient the paper motor connector toward the rear of the printer.
Paper Drive Motor
Screws,
3 places
Lower Drive Belt
Idler Bracket
Upper Drive Belt
Figure 38. Paper Drive Motor location.