TC Electronic D-TWO User Manual - page 12
14
SETUP
MIDI Sys-Ex ID
Determines the Sys-Ex ID number of the unit.
All effects parameters can be changed through MIDI
Sys-Ex via an external MIDI device. In order to define
which unit the sent MIDI Sys-Ex information should reach,
the appropriate ID number must be set.
Bypass Mode
There are three different Bypass modes:
0% Mix
The Input signal is passed directly to the Output.
FX Input
Shuts off the Engine Input in order to let the effect "ring
out", but leaves the same amount of dry signal through the
unit.
FX Output
Shuts off the Engine Output in order to kill the FX
instantaneously, but leaves the same amount of dry signal
coming through.
Pedal Setup
The pedal Input of the DTWO can recognize two pedals
simultaneously. One on the tip, and one on the ring of the
1/4 jack connector.
The Ring pedal is fixed to Tap tempo.
The Tip pedal can be set to Bypass, Tap tempo or Rhythm
tap. The Pedal used must have a momentary switch.
View Angle
Adjusts the intensity of the back light.
Delay Mode
Select between Stereo or Mono.
Reverse Offset
Offsets the Reverse Delay with 0-200ms. This enables you
to tailor the feel of the Reverse Delay to the source
material.
MIDI Tempo Sync.
Range: 2/1, 1/1, 1/2, 1/4.
Locks the Delay to the incoming MIDI clock, enabling the
DTWO to be synchronized to any MIDI device, e.g. a
sequencer.
The DTWO owns the ability to subdivide the incoming
MIDI clock in order to adapt the Delay to very fast or very
slow tempo arrangements, e.g. selecting the 1/2 setting will
lower the incoming sync to half tempo.
MIDI Channel
Range: Off/1-16/Omni.
Sets the responding MIDI channel of the DTWO.
MIDI CC
Range: On/Off.
Determines whether the DTWO should respond to MIDI
Continuous Controllers or not.
Program bank
Determines which bank an external MIDI device will
address in the DTWO when sending a program change.
The options are: Factory, User or External.
When External is selected controller #32 can be used to
address either the Factory or the User bank.
Factory bank:
Controller #32=0
User bank:
Controller #32=1
MIDI Bulk Dump
Press ENTER to perform a Bulk Dump of all presets to an
external MIDI device. The DTWO is always ready to
receive MIDI Bulk Dump information.