TC Electronic D-TWO User Manual - page 5
7
FRONT PANEL
FILTER
CHORUS
RECALL
EDIT
FEEDBACK
REVERSE
DYNAMIC
PINGPONG
STORE
SETUP
BYPASS
DELAY & FEEDBACK
FUNCTIONS
EFFECTS
CONTROL
ENTER
DELAY
SPATIAL
TAP
RHYTHM
DOUBLE CLICK TO EDIT
SET REPEATS
DELAY/TAP key
This key has two main functions:
- When the DELAY key LED is
lit, the DELAY wheel changes
the Delay time when dialed.
- When the key is tapped the
DTWO measures the time
between the last two taps and
the Delay time is calculated
according to the selected
subdivision.
FEEDBACK/RHYTHM key
This key has three main functions:
- When the LED is lit the
DELAY wheel is changing
the Feedback level or %.
- When the key is pressed and
held, the DELAY wheel changes
the number of repeats.
- Tap a rhythm pattern of up to
10 taps.
DELAY & FEEDBACK wheel
Sets the Delay time or Feedback
depending on what is selected.
SPATIAL key
Enables/disables the Spatial
function. Double click shortcuts to
the Spatial parameters.
Options are:
- Left channel offset +/-200ms.
- Phase reverse any channel.
RECALL key
Selects the Recall menu.
SETUP key
Enters the Setup menu.
This is where all I/O and
global parameters are located.
STORE key
Selects the Store menu. Presets can
be stored in the User bank only.
Location is selected using the
CONTROL wheel. Operation is
confirmed using ENTER.
ARROW UP/DOWN keys
Are used to move the cursor around
in the display.
CONTROL wheel
Is used to change values.
ENTER key
Confirms operations.
BYPASS key
Bypasses the unit. There are three
different Bypass modes.
- 0% Mix: Input signal is passed
directly to the Output.
- FX Input: Input bypass allowing
the effects to ring out.
- FX Output: Kills the effect
but keeps the direct signal level.
The Bypass mode is selected in
the Setup menu.
FILTER key
Enables/disables the Filter
functions. Double click shortcuts
to the High and Low Cut filter
parameters.
CHORUS key
Enables/disables the Chorus.
Double click shortcuts to the
Chorus parameters.
REVERSE key
Enables/disables the Reverse
Delay. Double click shortcuts to
the Reverse Delay parameters.
DYNAMIC key
Enables/disables the Dynamic
Delay. Double click shortcuts to
the Dynamic Delay parameters.
PING PONG key
Enables/disables the PingPong
functions. Double click shortcuts
to the PingPong parameters.
EDIT key
Enters the general Edit list. This
is where all preset processing
parameters are located. Use the
ARROW keys to select parame-
ters.