TC Electronic D-TWO User Manual - page 4
6
FRONT PANEL
MULTI SPECTRAL LCD DISPLAY
POWER
1
LEVELS
INPUT
MIX
EDITED FACTORY USER MIDI IN
User Preset
MULTITAP RHYTHM DELAY
TWO
D
0
O
3
6
1
1
2
8
24
40
INPUT
MORE
-dB
ms
Rhythm
BPM
FB
FB
%
#
SUBDIV
DYN
FB FILTER
H
H
L
L
FILTER
PING PONG
1/2 T
1/4 T
1/8 T
1/16 T
POWER button
Power on/off.
IN LEVEL knob
Adjusts the Input level.
At center position a relay will
switch the Input circuit between
consumer and pro level. This will
insure optimal Input gain range
and superb signal to noise ratio
is achieved.
MIX knob
Adjusts the global mix between
dry and wet signal. Fully clock-
wise position is 100% effect.
IN meters
The IN Peak meter shows the
Input level of left and right
channels. The meter range is:
0, -3, -6 ,-12, -18, -24, -40dB.
OVERLOAD LEDS
The OVERLOAD LEDs indicate
one of two situations:
- The Input level is too hot and
therefore overloading.
- There is an internal DSP
overflow.
The Overload LED is lit when
1 sample is @ 0dBFS.
DELAY TIME indicator
The DELAY TIME indicator can
display Delay time in either
ms (milliseconds) or BPM
(Beats Per Minute). This is
selected in Setup. The ms or
the BPM icon next to the Delay
time will be lit accordingly.
The tempo is also indicated via
the blinking TEMPO /RHYTHM
indicator.
SUBDIVISION indicator
The selected subdivision
determines the recalculation of
the tapped tempo. Example:
At 120BPM you tap 1/4 notes.
The tapped time equals 500ms.
If the Subdivision is set to 1/8,
the DTWO now recalculates
the Delay time to 250ms.
DYNAMIC meter
Indicates the gain reduction on
the Delay Output when using
the Dynamic Delay algorithm.
EDITED icon
This icon will be lit as soon as
the current recalled preset has
been modified.
FACTORY/USER icon
Shows whether you are
operating in the Factory or the
User bank.
MIDI IN icon
Indicates the presence of
incoming MIDI information.
SAMPLE RATE indicator
The SAMPLE RATE indicator
shows the clock source and the
incoming master clock.
The DI icon will be blinking if
no clock or unacceptable clock
is found.
FEEDBACK %
The amount of level fed back to
the Delay line. Indicates the
Decay time of the Delay
repeats.
FEEDBACK #
The exact number of repeats.
FB FILTER LEDS
Indicates the Feedback High
and Low Cut filter setting.
FILTER LEDS
Indicates the overall High and
Low Cut filter setting.
PINGPONG LEDS
Indicates the panning carried
out.